🔧Raspberry Pi Launches $600 Programming Jig for CM5 Provisioning
CM5 provisioning just got a lot easier with this new tool
TL;DR
Raspberry Pi introduces a $600 device to simplify CM5 board provisioning, integrating the host and module interface into one box for faster, more efficient setups.
Raspberry Pi has released a $600 Programming Jig designed to streamline the process of setting up Compute Module 5 (CM5) boards. This new tool combines the provisioning host and module interface into a single unit, eliminating the need for an additional IO board. Developers can now provision CM5 devices one at a time with ease, reducing setup time from hours to minutes. The Programming Jig supports initial configuration through Raspberry Pi Imager and installs an operating system and security settings on each CM5 board within 90 seconds.
Key Points
The Raspberry Pi Programming Jig costs $600 and integrates the host and module interface into one unit.
Provisioning a single CM5 board takes about 90 seconds, significantly speeding up setup times.
Once configured, placing a CM5 in the clamp initiates provisioning automatically.
A green status LED indicates when the module is ready to be removed after successful installation.
Initial setup involves writing the jig's operating system and configuring it with Raspberry Pi Imager.
Why It Matters
If you're setting up multiple CM5 boards, this Programming Jig cuts provisioning time from hours to minutes. It eliminates the need for additional IO boards and simplifies the process of installing an OS and security settings on each board.
Frequently Asked Questions
Why does this matter?
If you're setting up multiple CM5 boards, this Programming Jig cuts provisioning time from hours to minutes. It eliminates the need for additional IO boards and simplifies the process of installing an OS and security settings on each board.
What happened?
Raspberry Pi introduces a $600 device to simplify CM5 board provisioning, integrating the host and module interface into one box for faster, more efficient setups.
Comments
Be the first to comment
Enjoyed this article?
Get it daily. 7am. Free. Reads in 5 minutes.
Join 3,191 builders reading daily.