Skip to content
Source: IEEE Spectrum

🛩️Skydio's F10 Drone Ditches Circles With a Lopsided Wing Camera

Your fixed-wing drone footage just got a lot steadier

TL;DR

Skydio's F10 is a fixed-wing camera drone with a wingtip-mounted camera, asymmetric wings, and uneven motors. It flies up to 100 mph for 2 hours and lands itself. For anyone tracking targets from the air, it finally solves the orbit problem.

Skydio built a drone that looks wrong on purpose. The F10 puts its camera on one wingtip, which means the wings and motors are deliberately lopsided. Fixed-wing drones usually track targets by circling them, and at low altitude the wing or tail blocks the shot. Moving the camera out to the wingtip fixes that. If you build autonomous inspection, mapping, or surveillance pipelines, this is the part to watch. The F10 flies autonomously from hover to forward flight and back, and it launches, recovers, and recharges without a human touching it. Its control stack runs on model predictive control, and the drone can be steered remotely over dual 5G cellular modems. That means the flight logic and telemetry you'd build around it are real software problems, not hardware hacks. The specs: top speed is 100 mph, max flight time is 2 hours, and it carries an integrated parachute for emergencies. On the dock side, the MegaDock handles up to five F10s and runs continuous operations with three flying while two recharge. A robot arm catches each drone out of the air. The design also took internal pushback, so the asymmetry wasn't an easy sell.

Skydio's F10 Drone Ditches Circles With a Lopsided Wing Camera — IEEE Spectrum

Key Points

1

The F10 reaches a maximum speed of 100 miles per hour, which is fast enough to cover serious ground during autonomous surveillance or inspection runs.

Keep reading — it's free

Enter your email to keep reading — plus the best of AI & tech, daily. Free, forever.

Also get
or

Already a member? Sign in

SkydioF10fixed-wing dronesautonomous flightmodel predictive control

Comments

Subscribe to join the conversation...

Be the first to comment