🎮YouTuber Cranks Up Game Boy E-Paper Display to 30 FPS
30 FPS on an e-paper display? That's a big deal
TL;DR
A YouTuber built a 30 FPS grayscale Game Boy using an e-paper display, achieving a 300 ms refresh rate. The custom driver allows for four shades of grey and reduces image ghosting, but may impact panel longevity.
A YouTuber has pushed an e-paper display to 30 frames per second for a grayscale Game Boy build. The display, originally limited to 3.33 FPS, now supports four shades of grey and reduces image ghosting. This breakthrough could impact developers working on e-paper projects, but the long-term effects on panel life are still unclear. The custom driver, published on GitHub, shortens the waveform and enables per-pixel driving, achieving a 300 ms refresh rate. However, forcing custom waveforms and higher refresh rates can cause permanent damage to E Ink screens.
Key Points
A YouTuber built a 30 FPS grayscale Game Boy using an e-paper display, achieving a 300 ms refresh rate.
The custom driver allows for four shades of grey, reducing image ghosting and improving display quality.
The original driver supported 3.33 FPS, while the custom driver boosts performance to 30 FPS.
The custom driver was achieved after a month of work, published on GitHub for others to use.
Forcing custom waveforms and higher refresh rates can cause permanent damage to E Ink screens, raising concerns.
Why It Matters
If you're working on e-paper projects, this custom driver could significantly improve display performance. However, the potential for permanent damage means careful consideration is needed. Developers should weigh the benefits of faster refresh rates against the risk of panel degradation.
Comments
Be the first to comment
Enjoyed this article?
Get it daily. 7am. Free. Reads in 5 minutes.
Join 3,569 builders reading daily.